Speed Hump Section 250 x 350 x 50mm Black

Cost effective and durable solution for control of speed

Made from compression moulded 80% recycled rubber and 20% virgin rubber

2 x bolts and plugs included with each section and each end cap

Complies with Australian Standard AS2890.1:2004 (Type 2)

Specifications

Each piece measures 250 x 350 x 50 mm

Fitting Holes: Middle: 2 Holes x 12 mm diameter, End Cap: 2 Holes x 12 mm diameter

Weight: 4kg

Bearing Capacity : 20T

Reflector: 4 pieces supplied with each cats-eye hump section only

Tensile Strength: 6 MPa

Elongation at break: 200%

Hardness: 85A

Impact elasticity: 37%

Abrasion Performance: 0.28 cm3 / 1.61 km

Type 2 Speed Hump:

These speed hump sections comply with Australian Standard AS2890.1:2004 Parking Facilities, and are suitable as a Type 2 road hump. This meanas that they meet the design criteria for height, cross section, markings and ramp angles. The hump is 50mm high which conforms to the standard specification "must be between 25mm and 75mm". The cross section is flat on top not rounded, ensuring it meets the standard. Also, the speed hump sections have the required ramp angle of 2:1, and when installed in an alternating black/yellow pattern, they provide the appropriate 250mm wide striped markings.